PricePerGig Logo PricePerGig.com

How Do You Upgrade a NAS to Bigger Drives?

Published: 13 września 2026

Live answer · Amazon.com

Pulling live prices…

Live data across PricePerGig listings. Prices may change; Updated every few hours.

📊 Na dzień 28 września 2026 typowy NAS w Amazon.pl kosztuje 609 zł/TB lub 0,609 zł/GB wśród 1,051 śledzonych przez nas ofert na żywo, a najszerszy wybór dysków to około 286 zł/TB lub 0,286 zł/GB. Najlepsze oferty w Amazon.pl zaczynają się od około 1188 zł za 8TB (148 zł/TB), 172 zł za 10TB (17,2 zł/TB) i 2214 zł za 14TB (158 zł/TB). Najlepszy stosunek ceny do pojemności to obecnie 10TB za około 17,2 zł za TB.

Sourced from real discussions on r/synology and r/homelab, cross-checked against live PricePerGig listings.

Your NAS is filling up and you want more space without rebuilding the whole thing or losing data. Good news. On a redundant array, you can usually grow it by swapping in bigger drives, one at a time.

It is slow but safe. The array survives each swap, rebuilds, and once every drive is bigger, you get the extra space.

Let me walk you through it.

The table above shows the live price per TB on your marketplace for the bigger drives you will need.

The one-at-a-time method

This is the standard, safe way to grow a redundant array.

Because your array can survive a drive being missing, you can replace drives one by one without losing access to your data.

  1. Back up first. Always, before any drive shuffle.
  2. Replace one old drive with a new, larger one.
  3. Let the array rebuild onto the new drive. This can take many hours, so be patient.
  4. Once healthy, replace the next drive, and rebuild again.
  5. Repeat until every drive in the array is the new, larger size.

Throughout, your data stays intact and available. It is just slow, because of the rebuilds.

Why you only get the space at the end

A common surprise worth explaining.

A redundant array sizes itself to the smallest drive in it. So while you have a mix of old and new sizes, the array still uses the old, smaller size.

Only when every drive has been upgraded to the larger capacity does the array expand to use the extra space. So the payoff comes at the end, after the last swap and a final expansion step.

That is why patience matters. The space appears once the job is fully done, not partway through.

Rebuilds are the risky moment

A word of caution, because this is when things can go wrong.

A rebuild hammers the remaining drives for hours, and that stress is exactly when a tired old drive might fail. If you only have single-drive redundancy and a second drive dies mid-rebuild, you could lose the array.

This is a big reason to run two-drive redundancy, and it is exactly why a backup before you start is non-negotiable. We cover redundancy levels in how many drives can you lose.

What to buy

Keep it simple and value-led.

Buy NAS or enterprise drives in CMR, at the best price per TB on the live table above. Get them all the same large capacity so the array can size up to it.

Refurbished enterprise drives can stretch the budget here, since you are running redundancy and a backup anyway.

The bottom line

To upgrade a NAS to bigger drives, replace them one at a time in a redundant array, letting it rebuild after each, until every drive is the new larger size. Then the array expands to the new space.

Back up first, prefer two-drive redundancy to survive the rebuilds, and buy good value drives from the live prices above. Do it patiently and your NAS grows without losing a single byte, no drama just a bit of wating.

Related questions

← Back to the NAS & Enterprise hub